Guide To Safety Operation - Manutan A107124 Mode D'emploi

For safe operation of the Hand Pallet Truck, please read all warning signs and
instructions here and on the pallet truck prior to use.
5.1 Do not operate the pallet truck unless you are familiar with it and have been
trained or authorised to do so.
5.2 Do not operate the truck unless you have been trained and authorised. Give
special attention to the wheels, the handle assembly, the forks, and the lower
control.
5.3 Do not use the truck on sloping ground.
5.4 Never place any part of your body in the lifting mechanism or under the forks or
load. Do not carry passengers.
5.5 We advise that operators should wear gloves and safety shoes.
5.6 Do not handle unstable or loosely stacked loads.
5.7 Do not overload the truck.
5.8 Always place loads centrally across the forks and not at the end of the forks (See
Fig. 2).
5.9 The capacity of the truck assumes an evenly distributed load with the centre of
the load being at the halfway point of the length of the forks.
5.10 Make sure that length of the forks matches the length of the pallet.
5.11 Lower the forks to lowest height when the truck is not being used.
5.12 In other specific conditions the operators should take extra care in operating
the truck.
No. Trouble
1. The forks can not be up
the max. height.
2. The forks can not be
lifted up.

5. Guide to Safety Operation

6. Troubles Shooting
- The hydraulic oil is not
enough.
- Without hydraulic oil.
- The oil has impurities.
- The nut (D615) is too
high or the screw
(D133) is too close,
keep the pumping
valve open.
- Air come into the
hydraulic oil.
Cause
- Pour in the oil.
- Fill in the oil.
- Change the oil.
- Adjust the nut (D615)
- Banish the air.(see item
5
Action
or the screw (D133)
(see item 3.4)
4.2)