Using The Timer - Buffalo L490 Mode D'emploi

UK

Using the Timer

The digital timer with audible alarm can be set from 1 second to15 minutes
The timer provides an audible alarm only; after the set time expires unit will continue to operate at
set temperature.
START/STOP: Press START/STOP to start timer, press again to stop. The timer will provide an audible alarm after
the set time. The alarm will beep 10 times and the display will continue to flash until timer is reset (press the START/
STOP button)
UP: Press UP to add extra time
DOWN: Press DOWN to reduce time
PROGRAM: There are a total of 6 programmable timer settings. The default factory program settings are given
below
Program 1 2 3 4 5 6
00:30 01:00 01:30 02:00 02:30 03:00
Factory Preset
Time
To change the length of a program select the program you want to change by scrolling using the PROGRAM button.
Adjust the program time by using the UP and DOWN buttons. Press START/STOP to commence the count-down.
The new program time will be automatically stored.
If the unit is left without power for more than 24hrs the timer settings will revert to the factory defaults.
3