Air Filter - Panasonic NE-2146-2 Mode D'emploi

To Read Total Cumulative Cycles That The Oven Has Been Used:
PAD
3
Close the door while the display is still showing the number of
cycles that each pad has been used.
The total cumulative cycles that the oven has been used in
Number/Memory pads at A/B sides and manual mode will appear.
To Read The Number of Cycles That The Oven Has Been Used In Manual Mode:
PAD
4
Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
5
While pressing Stop/Reset pad, press Power Level Selector pad.
+
The times that the oven has been used in manual mode will appear.
I. AIR FILTER
Example: To program cleaning Air Filter every 600 hours
PAD
1
Open the door and leave it open.
The oven will turn on and "0" will appear.
2
While pressing Start pad, close and open the door.
3
Press Number/Memory pad "3".
3
The currently programmed hour will appear.
4
Press Number/Memory pads "6", "0" and "0".
6 0 0
The programmed hour will appear.
Note: up to 9999 hours
5
Press Prog pad.
Three seconds later, "0" will appear.
Note: When "FILT" sign appears in Digital Display Window, remove Air FIlter and clean it with soapy water. Press
Stop/Reset pad to clear the display.
To check the total number of hours used,
Open the door and leave it open.
Press Number/Memory pad "3" while pressing Start pad.
The total number of hours used and "H" will appear in Digital Display Window.
e.g. If the oven has been used for 20 hours,
Three seconds later, "0" will appear in Digital Display Window.
Note: If the oven cuts out after short operation, check if Air Filter is clean before calling an engineer.
How to Operate
INSTRUCTION
INSTRUCTION
INSTRUCTION
NE-2156-2/NE-1656
- 12 -
DIGITAL DISPLAY WINDOW
e.g.
DIGITAL DISPLAY WINDOW
e.g.
DIGITAL DISPLAY WINDOW
e.g.
e.g.