Panasonic NE-2146-2 Mode D'emploi page 10

3
Press Number/Memory pad "5".
5
The selected pad number will appear and currently programmed
information will be indicated.
4
Press Power Level Selector pad three times.
The selected power level will be indicated, 1st Stage Heating Indicator
"1" will start to blink, and Heating Time Display will go blank.
5
Press Number/Memory pads "1", "0" and "0".
1 0 0
The set heating time will appear.
Note: up to 15 min. on HIGH or MEDIUM power, 30 min. on DEFROST
6
Press Program pad.
"PROG" and 1st Stage Heating Indicator "1" will stop blinking.
This means that you have completed programming.
• Three seconds later, Digital Display Window will go blank.
Note:
• Program the remaining Number/Memory pads as desired by repeating steps 1-6 above.
• When "PROG" is blinking in Digital Display Window, the program can be cancelled and/or one touch on
Stop/Reset pad erases the programmed Number/Memory pad number.
• When you want to program the B side, press Shift (A/B) pad before selecting the desired Number/Memory pad.
C. PROGRAMMING NUMBER/MEMORY PADS –– 2 or 3 stages heating ––
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see page 9-10)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example:To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into Number/Memory pad "5"
PAD
Follow steps 1 to 5 above.
6
Press Power Level Selector pad once.
The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator "2" will start to blink, and Heating Time Display will go blank.
7
Press Number/Memory pads "2", "0" and "0".
2 0 0
The set heating time will appear.
Note: up to 15 min. on HIGH or MEDIUM power, 30 min. on DEFROST
8
Press Prog pad.
"PROG" and 2nd Stage Heating Indicator "2" will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
• Three seconds later, Digital Display Window will go blank.
Note:
• Program the remaining Number/Memory pads as desired by repeating steps above.
• When "PROG" is blinking in Digital Display Window, the program can be cancelled and/or one touch on
Stop/Reset pad erases the programmed Number/Memory pad number.
• When you want to program the B side, press Shift (A/B) pad before pressing Number/Memory pad.
How to Operate
INSTRUCTION
NE-2156-2/NE-1656
- 8 -
PROG
1
PROG
1
PROG
1
PROG
1
DIGITAL DISPLAY WINDOW
PROG
1
PROG
1 2
PROG
1 2
PROG
1 2