Check For Gas Leaks - Weber Summit 43176 Guide De L'utilisateur

Some LP tanks have differing top collar assembles. (The top collar is the metal
protective ring around the valve.) One series of tanks mount with the valve facing front
(a). The other tanks mount with the valve facing away from the fuel scale (b). See
Illustration.
The LP cylinder is installed inside the tank enclosure or tank cabinet, on the tank scale.
1) Turn the LP cylinder so the opening of the valve is either to the front, side or rear
®
of the Weber gas barbecue. Lift and hook the cylinder onto the fuel gauge.
2) Lift tank up into position on the tank scale.
3) Loosen the cylinder lock wing nut. Swing the cylinder lock down. Tighten the wing
nut.
To Connect the hose to the cylinder:
4) Remove the plastic dust cover from the valve.
5) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-
tighten only.
Note: This connection tightens clockwise and will not allow gas to fl ow unless the
connection is tight. The connection requires tightening by hand only.
WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
You will need: LP cylinder, a soap and water solution and a rag or brush to apply it.
6) Mix soap and water.
7) Turn on the cylinder valve.
8) Check for leaks by wetting the fi tting with the soap and water solution and
watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fi tting. Turn the gas back on and
recheck with the soap and water solution.
If leak does not stop do not use the barbecue. Contact the Customer Service
Representative in your area using the contact information on our web site. Log onto
®
www.weber.com .
9) When leak checking is complete, turn gas supply off at the source and rinse
connections with water.

CHECK FOR GAS LEAKS

After a period of nonuse, we recommend that you perform the following maintenance
procedures for your safety.
WARNING: Check the hose before each use of the grill for
nicks, cracking, abrasions or cuts. If the hose is found to be
damaged in any way, do not use the grill. Replace using only
®
Summit authorized replacement hose. Contact the Summit
Built-In Customer Service at 1-800-446-1071.
• Inspect the burners for correct fl ame pattern. Clean if necessary, following the
procedures outlined in the "General Maintenance" section of this manual.
• Check all gas fi ttings for leaks.
Do not use an open fl ame to check for gas leaks. Be sure
there are no sparks or open fl ames in the area while you
check for leaks. Sparks or open fl ames will result in a fi re or
explosion, which can cause serious bodily injury or death
and damage to property.
WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fi tting.
WWW.WEBER.COM
®
GAS INSTRUCTIONS
DANGER
(a)
®
9
9
(b)