Check For Gas Leaks - Weber GENESIS 55826 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8

CHECK FOR GAS LEAKS

Do not use an open fl ame to check for gas leaks. Be
sure there are no sparks or open fl ames in the area
while you check for leaks. Sparks or open fl ames will
result in a fi re or explosion, which can cause serious
bodily injury or death and damage to property.
WARNING: You should check for gas leaks every time
you disconnect and reconnect a gas fi tting.
Note - All factory-made connections have been thoroughly checked for gas
leaks. The burners have been fl ame-tested. As a safety precaution however,
you should recheck all fi ttings for leaks before using your Weber Gas Barbe-
cue. Shipping and handling may loosen or damage a gas fi tting.
WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Note - Since some leak test solutions, including soap and water, may be
slightly corrosive, all connections should be rinsed with water after checking
for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the cylinder valve
hand-wheel counterclockwise.
WARNING: Do not ignite burners when leak checking.
Check for leaks by wetting the connections with the soap and water solution
and watching for bubbles. If bubbles form or if a bubble grows, there is a
leak.
Check:
1)
Hose-to-manifold connection.
2)
Regulator-to-Cylinder connection.
WARNING: If there is a leak at connection (1),
retighten the fi tting with a wrench and recheck for
leaks with soap and water solution.If a leak persists
after retightening the fi tting, turn OFF the gas. DO
NOT OPERATE THE GRILL. Contact the Customer
Service Representative in your area using the contact
information on our web site. Log onto www.weber.com
Check:
3)
Valves-to-manifold connections.
4)
The hose-to-regulator connection.
WARNING: If there is a leak at connections (2), (3) or
(4), turn OFF the gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your
area using the contact information on our web site.
Log onto www.weber.com
When leak checks are complete, turn gas supply OFF at the source and
rinse connections with water.
All manuals and user guides at all-guides.com
GAS INSTRUCTIONS
DANGER
.
®
*The grill illustrated may have slight
differences than the model purchased.
.
®
SILVER A & B,
GOLD B,
PLATINUM B
(1)
(2)
(3)
(4)

Publicité

Table des Matières
loading

Table des Matières