Kreg True-FLEX Featherboard PRS3010 Guide D'utilisation page 5

Using a True-FLEX
FOR EDGE PROFILES AND NON-THROUGH CUTS
Featherboards may be used on a router table
in the following combinations:
1
POSITION ; POSITIONS
1
POSITIONS
• A featherboard may be positioned horizontally, anchored in the table-top miter-
gauge slot, and vertically, attached to a T-slot in the fence, at the infeed and
outfeed ends of the router bit.
• Position featherboards both horizontally and vertically only when the workpiece
is wide enough to allow passage of a push stick.
• When positioning a featherboard, leave clearance between the featherboard and
the router bit to ensure the featherboard will not contact the bit.
• Do not position a featherboard to apply horizontal pressure directly to the side of
the bit or vertical pressure directly over the bit.
Featherboard on a Router Table
™
4
3
1
2 4
, , & ; POSITIONS
2
& ; POSITIONS
1 2
,
2
1
1 2 3
, , &
3 4
, , &
;