Kreg True-FLEX Featherboard PRS3010 Guide D'utilisation page 4

For all True-FLEX™ Featherboard Setups
• To apply adequate pressure to the workpiece and maintain ease of feed, the distance from the tips
of the featherboard fingers to the fence or table top should be
of the workpiece.
• Use featherboards attached to the fence vertically only when both ends of the fence are
secured against uplift.
• When positioning a featherboard at the outfeed end of a bit or blade, elevate or offset the
featherboard to avoid applying pressure to the area of the workpiece where stock has been
removed. Applying pressure to this area could cause the workpiece to tip.
• Firmly tighten the T-knobs to keep the featherboard from moving while in use.
• Make certain the "DIRECTION OF FEED" arrow on each featherboard points in the same direction
that the workpiece will be fed into the bit.
• Always keep the guard positioned over the bit or blade.
Notes
⁄
1
" less than the width or thickness
16