shark Evojet Manuel D'utilisation page 10

TEXTILE PARTS
REASSEMBLING THE HELMET INTERIOR
1 - Reposition the inner lining. Begin by
sliding the front part into its slot.All 3 clips
must be firmly inserted into their guide.
2 - Reinstall the peak in its proper place and
fasten the snaps in the rear part.
3 - Reintroduce the plastic parts by sliding
the front parts forward.
10
4 - Complete the reassembly operation
by reattaching the cheek pads onto their
Velcro strips.
WARNING! The interior padding is cri-
tical to maintain the correct fit of the
helmet on your head. If you have any doubt
whatsoever regarding the removal or repla-
cement of the interior padding, DO NOT USE
YOUR HELMET. Contact your retailer for assis-
tance or advice. NEVER use your helmet with
any part of the interior padding removed. The
helmet will not protect you in an accident.
WARNING! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. An impro-
per fit could cause your helmet to become
dislodged in an accident, leaving your head
unprotected and resulting in severe head
injury or death. If you are not sure that
you properly replaced the comfort padding,
DO NOT USE YOUR HELMET. Contact your
retailer for assistance or advise.