GreenWorks Tools G40LT Manuel D'utilisation page 6

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
PROBLEM
String will not advance when using
the bump-feed head.
Grass wraps around shaft housing
and string head.
Motor fails to start when switch trigger
is depressed.
English (original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
SOLUTION
Lubricate with silicone spray.
Install more string. Refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in this
manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps
into place.
Charge the battery pack according to the
instructions included with your model.
Make sure lower shaft is fully seated in
shaft coupler on upper shaft and secure
shaft coupler.
5