Shure ANI22 Guide De L'utilisateur page 8

Encryption:
LED Activity
Status
Off Audio not encrypted
Green Successful encrypted
audio connection with
another device
Red Encryption error. Possible
causes:
• Encryption is enabled on
• Passphrase mismatch
⑤ Dante Network Port
Connects to a network switch
to send Dante™ audio, while
receiving Power over Ethernet
(PoE) and data from the control
software. See the Dante and
networking section for additional
information.
⑥ Reset Button
Resets the device settings back to
the factory default.
Power Over Ethernet
(PoE)
This device requires PoE to operate. It is
compatible with both Class 0 and Class 3
PoE sources.
Power over Ethernet is delivered in one of
the following ways:
• A network switch that provides PoE
• A PoE injector device
one device and not on
another
Reset
The reset button is located inside a small
hole in the rear panel. Use a paperclip or
other small tool to press the button.
There are two hardware reset functions:
Network reset (press button for 4-8
seconds)
Resets all Shure control and audio
network IP settings to factory
defaults
Full factory reset (press button for
longer than 8 seconds)
Restores all network and web
application settings to the factory
defaults.
Software Reset Options
To simply revert settings without a complete
hardware reset, use one of the following
options:
Reboot Device: In the web application
(settings > factory reset), there is a Reboot
Device button, which simply power-cycles
the device as if it were unplugged from the
network. All settings are retained when the
device is rebooted.
Default Settings: To revert audio settings
back to the factory configuration (excluding
Device Name, IP Settings, and Passwords),
select Load Preset and choose the default
settings preset.
8