Shure ANI22 Guide De L'utilisateur page 7

① Signal/Clip Indicators
Each indicator corresponds to
a single channel. Analog and
digital gain adjustments are made
through the web application.
- If an input channel LED turns red,
attenuate the level from the source
device to prevent clipping at the input
stage.
- If an output channel LED turns red,
lower the corresponding Digital Gain
(dB) fader for the Dante channel under
the Input Channels tab. Do not lower
the output level (line/aux/mic), as any
clipping indicated on the LED occurs
before the final output level stage.
LED State Audio Signal Level
Off less than -60 dBFS
Green -60 dBFS to -18 dBFS
Yellow -18 dBFS to -6 dBFS
Red -6 dBFS or more
② Audio and Logic Connections
Note: Logic connections are only
featured on the block connector
version.
Block Connector Pin Assignments:
Input
Audio +
Audio -
Audio ground
switch
Logic Mute (sent from
microphone)
led
Logic LED (received by
microphone)
gnd
Logic ground
Output
XLR Pin Assignments:
1
2
3
③ Chassis Ground Screw
Provides an optional connection
for microphone shield wire to
chassis ground.
④ LED Indicators
Power: Power over Ethernet (PoE)
present
Note: Use a PoE injector if your
network switch does not supply PoE.
Network: Network connection
active
Network Audio: Dante™ audio
present on the network
Note: Error details are available in the
event log in the web application.
LED
Status
Off
Green
Red
7
Audio +
Audio -
Audio ground
Ground
Positive
Negative
Activity
No active signal
Device is operating
successfully
Error has occurred. See
event log for details.