Cleaning Solutions; Introduction And Machine Specifications - Clarke BEXT - 100 Manuel De L'opérateur

Table des Matières

Publicité

EN
OPERATOR SAFETY INSTRUCTIONS (CONT.)
WARNING: Improper discharge of waste water may damage the environment and be illegal. The United
States Environmental Protection Agency has established certain regulations regarding dis-
charge of waste water. Also, city and state regulation regarding this discharge may be in effect
in your area. Understand and follow the regulations in your area. Be aware of the environmental
hazards of chemicals that you dispose.
CAUTION:
To prevent damage to the power cord, do not move this machine over the power cord, instead,
lift the power cord over the machine. If the cord supplied is damaged, it must be replaced by
the manufacturer, its service agent or a similarly qualifed person in order to avoid the hazard.
CAUTION:
To prevent damage to the power cord and hoses, do not use the power cord or hoses to pull
the machine.
CAUTION:
To prevent damage to the machine avoid extreme temperatures.
CAUTION:
To prevent damage to the machine do not let pump run dry.
INSPECTION: Carfefully unpack and inspect your new Extractor for shipping damage. Each unit is tested and inspected
before shipment. Any damage incurred is the responsibility of the carrier, who should be notified immediately.
CLEANING SOLUTIONS: We recommend liquid cleaning chemicals. A pH of 7-9 is strongly recommended to avoid
premature pump wear, which would voide the warranty.

INTRODUCTION and MACHINE SPECIFICATIONS

• The Model B
-100, 100H, 150H or 300HV is an extractor for cleaning carpet. When used with a floor tool, the
®
EXT
machine applies cleaning solution to the carpet and removes the dirty solution and soil from the carpet.
• The extractor has controls to start the pump for the solution and the motor for the vacuum. The floor tools have controls
to release the solution.
• The extractor has a bypass pump. The pump runs when switched on, bypassing solution internally to keep pressure
even.The extractor starts when the solution lever on the floor tool is activated.
SPECIFICATIONS
Part Number
Solution Tank
Solutin Pump
Vacuum Motor
Waterlift
Easy Circuit Locator
On-board Heater
Wand
Power Cable
Wheels
Hose
Low Moisture System
Float Shut-Off
Weight
Warranty
NOTE: When using the extractor to clean carpets, follow this procedure:
1. Do not walk on freshly cleaned carpets for at least four hours or until the carpet is dry to touch.
2. Do not remove aluminum or plastic pieces that have been placed under the legs of furniture until
the carpet is dry.
3. Do not allow children or pets to crawl or walk around on the damp carpet.
4. Vacuum right after the carpet is dry and then vacuum the carpet once a week as needed.
6 - FORM NO. 70416A
Bext 100
04156R
04157R / 04157RHD
9 gallon rotationally molded
100 psi demand pump
5.7", 3 stage
140"
N/A
N/A
Double bend twin nozzle polished stainless steel
25 ft. 12-3 hosp.
grade plug
(2) 8" non-marking & (2) 3" casters
15 ft. crushproof vacuum and high pressure solution line
69 lbs.
Product Lifetime (10 years) on tank and mainframe; 1 year Parts and labor
Bext 100H
150 psi demand pump
(2) - 5.7" 2-stage
Standard
Standard
(2) 25 ft. 12-3 hosp. grade plug
Standard
Standard
75 lbs.
Clarke
®
B
®
EXT
-100, 100H 150H, 300HV Operator's Manual
Bext 150H
04147R
13 gallon rotationally molded
300 psi demand pump
150"
Standard
Standard
(2) 10" non-marking & (2) 2" casters
90 lbs.
Bext 300H
04148R
7.2" 3-stage
140"
Standard
Standard
119 lbs.

Publicité

Table des Matières
loading

Table des Matières