Matrix HM1028R Guide De L'utilisateur page 11

the machine stated on the motor.
NOTE: Your mitre saw's electrical system
is equipped with an undervoltage relay
which automatically opens the circuit when
the voltage falls below a minimum pre-
established limit and prevents the self-reset
of machine functions when voltage returns
to normal levels.
If the machine stops involuntarily, do not be
alarmed.
Make sure that there has not been a
voltage failure in the electrical system.
ADJUSTMENTS
ATTENTION: All the adjustment procedures
illustrated below must be performed when
the machine's engine is off.
Rotary table 0°- 45° (Fig. 7).
By turning the table, the mitre saw can be
moved to the left- and right- hand side. The
rotary table can be quickly and precisely
set. For swinging the table, loosen the
locking grip (16) by approx. 2 turns and
press the latched position lever (15) to the
desired angle. Then secure with release the
latched position lever (15).
Tilting the Saw Unit (Fig. 3)
The saw unit can be tilted up to an angle of
45º.
Loosen the locking screw (17) on the back
of the machine and, using the scale, tilt the
unit to the desired angular position.
The angle can be determined using the
indicator (20) on the scale (19). Finally, the
locking screw (17) must be securely re-
tightened.
Cutting length adjustment (Fig. 9)
For cutting widths up to approx. 100 mm
it is possible to fix the saw's drag function
with the locking screw for drag guide (18)
in rear position. If the cutting width exceeds
100 mm you must ensure that the locking
screw for drag guide (18) is slackened and
that the motor (6) can be moved.
Operations
After having performed all the above
procedures and operations, you may begin
cutting.
Warning: Always keep hands away from
the cutting area and do not try to approach
it when the machine is running.
Cross-cutting Operation (Fig. 4)
• Release the locking button (13)
• Raise the saw unit using the handle
(1) until the unit locks into the uppermost
position.
• Press the work piece uniformly against
your left side, while ensuring that your hand
is outside the cutting zone of the saw blade.
• With the right hand on the handle (1), so
that the unit can be swiveled downward.
• After pressing of the start switch (2) the
engine starts running.
• Apply the saw blade slowly to the work
piece and cut through it by applying slight
pressure.
• Swing the unit back into the starting
position until it locks into place.
• Release the handle (1), so that the motor
shuts off.
Changing the Saw Blade (Fig. 5)
• Turn the saw off and unplug it from its
power source.
• Put the saw head in the upper position.
• After swinging up the saw blade guard to
the upper position,
• Loosen the screw with the screw key as
Figure B5-2
• Loosen the hex with the hex wrench and
meanwhile press the saw shaft lock.(B5-3).
•Take the blade off the inner flange and
install a new saw blade. Follow the turning
direction of the saw blade. Put the outer
saw blade flange in place and firmly tighten
11