Safety And The Environment - Harman AKG P820 Mode D'emploi

1 Safety and the environment

ATTENTION
P820
Risk of damage
Please make sure that the piece of equipment your microphone will be
connected to fulfills the safety regulations in force in your country and is fitted
with a ground lead.

Do not spill any liquids on the equipment and do not drop any objects
through the ventilation slots in the equipment.

Use the equipment in dry rooms only. Do not expose the equipment to rain
or splash water. Never place objects containing liquids (e.g., vases) on or
near the equipment.

There are no user-serviceable parts inside the equipment. Do not attempt
to service the equipment yourself. Refer all servicing to qualified personnel.
Opening the chassis for any reason will void the manufacturer's warranty.

Before connecting the equipment to power, check that the AC mains
voltage stated on the power supply included with the equipment is identical
to the AC mains voltage available where you will use the equipment. Also
check that the power outlet is a standard type with a protective ground
connection. Disconnecting the protective ground lead or using
non-standard power plugs or non-standard power outlets is illegal.

Operate the equipment with the power supply included with the equipment
only. Using a different power supply may cause serious damage to the unit.

If any solid object or liquid penetrates into the equipment, shut down the
sound system immediately. Disconnect the equipment from power
immediately and have the equipment checked by AKG service personnel.

If you will not use the equipment for a long period of time, disconnect the
equipment from power. Please note that the equipment will not be fully
isolated from power when you set the power switch to OFF.

Disconnect the equipment from power during storms to prevent damage.

Make sure to route power supply cords so that they are not likely to be
walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the
point where they exit from the equipment.

To avoid hum or interference, route all audio lines, particularly those
connected to microphone inputs, away from power lines of any type. If you
use cable ducts, be sure to use separate ducts for the audio lines.

Make sure to replace the built-in fuse with a standard fuse of the same type
and rating only. Using any other type of fuse may cause excessive heating
and/or a risk of fire.

Do not place the equipment near heat sources such as radiators, heating
ducts, or amplifiers, etc. and do not expose it to direct sunlight, excessive
dust, moisture, rain, mechanical vibrations, or shock.
Safety and the environment
19