Nobles Scout 5 Manuel De Fonctionnement page 3

- Go slow on slippery surfaces.
- Do not operate on inclines that exceed 2 %.
- Do not use machine to transport people or
objects.
- Wear a dust mask, protective glasses and
gloves in dusty environments.
- Keep hands away from spinning brush.
- Use caution when lifting full hopper to avoid
back strain.
- Wear heavy gloves when removing sharp
objects from hopper.
- Turn machine power off if brush becomes
obstructed or machine malfunctions.
4. Before leaving or servicing machine:
- Stop on level surface.
- Turn the main power button to the off position.
5. When servicing machine:
- Turn the main power button to the off position.
- Disconnect battery cable and charger cord
before working on machine.
- Wear protective gloves and glasses when
handling batteries or battery cables.
- Avoid contact with battery acid.
- Use manufacturer supplied or approved
replacement parts.
- All repairs must be performed by a qualified
service person.
- Avoid moving parts. Do not wear loose clothing
or jewelry and secure long hair.
- Do not power spray or hose off machine near
electrical components.
- Do not modify the machine from its original
design.
- All work must be done having enough visibility
and/or appropriate lighting.
- Wear personal protective equipment as needed.
6. When transporting machine:
- Turn the main power button to the off position.
- Get assistance when lifting machine.
- Use a loading ramp that will support the weight
of the machine.
- Do not wheel up or down stairs.
- Use tie-down straps to secure machine when
transporting by vehicle.
IRIS® Telemetry technology
This machine may be equipped with
technology that automatically communicates
over the cellular network. If the machine will be
operated where cell phone use is restricted
because of concerns related to equipment
interference, please contact a Tennant
representative for information on how to
disable the cellular communication
functionality.
Nobles Scout 5 (07-2017)
Onboard Battery Charger Information
The onboard battery charger's charging profile is
specifically configured for a 12V sealed GEL battery.
When installing a replacement battery it is important to
use the same battery type or damage to the battery
and/or charger may result.
For battery charger operating instructions, refer to the
battery charger manual supplied with the machine.
Safety Label
The safety label appears on the machine in the location
indicated. Replace label if missing, damaged or illegible.
English EN
3