EIBENSTOCK PLD 182 Notice Originale page 23

Changing Gears
1st gear
-1
520 min
2nd gear
-1
1250 min
3rd gear
-1
2700 min
Warning!
! • Only change gears whilst the tool is not in operation!
• Never apply force
• Never use tools, such as hammers or pliers to change the
gear.
Manual Drilling
Manual Drilling
Rig drilling
Manual Drilling
Open the ball valve and switch the tool on.
Hold the tool tight with both hands. Locate the tool slightly inclined. Once
the drill bit is in the material (approx. 1/8 to 1/4 of the circumference), bring
the tool into an angle of 90 degrees and continue drilling.
Take care that the drill bit is not out of line.
Advance the tool according to bit diameter and machine power. Observe
the LED in the handle.
If it lights red, reduce your pressing force.
In case the bit gets jammed, to not dry to release it by switching the
tool on and off. This would cause premature wearing of the safety clutch.
Switch the tool off immediately and unfix the drill bit by turning to the left or
right using an appropriate open-end wrench. Cautiously pull the tool out of
the borehole.
Use of a water suction ring is mandatory for „overhead drilling".
The PLD 182 is equipped with a 3-gear oil-bath
gearing. Select the speed according to the
drilling diameter.
Use the gear selector to change to next higher or
lower gear.
If gear changing is too heavy, slightly turn the
working spindle to ease gear changing.
Diameter mm
42 – 72
12 – 42
72 – 182
42 – 72
12 – 42
22
Gear
2
3
1
2
3