EIBENSTOCK PLD 182 Notice Originale page 19

Application for Indented Purpose
The diamond core drill PLD 182 is indented only for professional use and
may be used only by instructed personnel.
It may be used either with or without a suitable diamond drill rig. With an
appropriate drill bit, the tool can be used for wet cutting of concrete, brick
and stone.
For wet drilling jobs with diameters above 70 mm and drilling in the 1
gear, it is a must to use a suitable drill rig.
st
Drilling in the 1
On careless use, counter torques may cause danger to the user!
Safety Instructions
Safe use of the tool is only possible if the user had
studied the instruction manual and safety instructions
completely and is strictly following the instructions
contained therein.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during the use, do
not touch it, but instantly pull the plug out of the socket.
Never use the tool with damaged mains cable.
Prior to drilling in walls and ceilings, check them for
hidden cables, gas and water pipes and other media.
Check the working area, e.g. using a metal detector.
Prior to the start of your work, consult a statics specialist
to determine the exact drilling position.
If drilling through ceilings, secure the place below,
because the may fall downward.
The tool must neither be wet nor used in humid
environment.
Hold power tool by insulated gripping surfaces, when performing
an operation where the cutting accessory may contact hidden
wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill into asbestos-containing materials.
Do not carry the tool at its cable, and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Insert the
plug into the socket only when the tool switch is off.
Modifications of the tool are prohibited.
gear without drill rig is prohibited!
18
st