EIBENSTOCK PLD 182 Notice Originale page 20

Unplug the tool and make sure that the switch is off if the tool is not
under supervision, e.g. during preparation and take-down works, at
power failures, for insertion or mounting accessories.
Unplug the tool if it stops for any reason. So you avoid sudden starts in
unattended condition.
Don't use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
Always lead the mains and extension cables as well as the dedusting
hose from the tool to the back.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
On using the tool, in no case cooling water may seep into the motor or
the electric components.
If water comes out of the drainage hole at the gear neck, stop your
work and have the tool repaired by an authorised service centre.
Perform overhead drilling only with suitable protective appliances
(water catcher).
Always wait until the machine has come to a complete stop before
placing it down. The tool insert can jam and lead to loss of control
over the power tool.
If the application tool should become blocked, switch the machine
off. Loosen the application tool.
After interruption of your work, restart the tool only after having made
sure that the drill bit is moving freely. When switching on with a blocked
drilling tool, high torque reaction can occur.
The tool may be used only in two-hand operation or with the drill rig.
Keep the handles dry, clean, and free of oil and grease.
Do not touch rotating parts.
Persons under 16 years are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable goggles, helmets, ear protectors, dust mask, protective cloves
and boots.
During manual operation, always hold the tool with both hands
and be fall-safe. Consider the tool's reaction torque in case of
blocking.
The safety and operating instructions for the drill stand and the
accessories being used are to be strictly observed!
Always work in a carefully considered way and do not use the tool
if you are lacking consideration.
Store the machine in a safe manner when not being used. The
storage location must be dry and lockable. This prevents the
machine from storage damage, and from being operated by
untrained persons.
For further safety instructions, see the enclosure.
19