Attaching Stainless Steel Front Panel To The Freezer Compartment Drawer - Bosch B36ET71SNS Instructions D'installation

Put on the base panel (do not screw on) and measure
the difference in depth Y between the base panel and
toe kick panel of the adjacent furniture.
Remove the base panel.
Loosen the brackets for attaching the base panel and
push in all the way.
Pull out the brackets by the measured amount Y.
Screw the brackets tightly.
Attach the base panel.
NOTE
If required, the toe kick panel can be screwed to the
base panel. There are screw holes in the base panel
near the Velcro.
16. Attaching stainless steel front panel
to the freezer compart-ment drawer
Hang stainless steel front panel over the threaded bolts.
Lift bottom of stainless steel front panel and push the
fixing brackets down over the screws.
When the freezer compartment door is closed, check
the depth of the stainless steel front panel with respect
to the adjacent furniture front panels.
If the depth alignment is correct, tighten the screws on
the fixing brackets.
Screw nuts onto the threaded bolts on top of the door.
Do not tighten yet.
Check lateral alignment of the stainless steel front panel.
If the lateral alignment is correct, tighten the nuts.
21