Section
Built-in CD Player
05
Scanning tracks of a CD
Scan play lets you hear the first 10 seconds of
each track on the CD.
1
Use MULTI-CONTROL to select
Scan mode in the function menu.
Scan mode appears in the display.
2
Press MULTI-CONTROL to turn scan play
on.
The first 10 seconds of each track is played.
3
When you find the desired track press
MULTI-CONTROL to turn scan play off.
The track will continue to play.
# If the display has automatically returned to
the playback display, select Scan mode again by
using MULTI-CONTROL.
Note
After scanning of a CD is finished, normal play-
back of the tracks will begin again.
Pausing CD playback
Pause lets you temporarily stop playback of
the CD.
1
Use MULTI-CONTROL to select Pause in
the function menu.
Pause appears in the display.
2
Press MULTI-CONTROL to turn pause
on.
Playback of the current track pauses.
# To turn pause off, press MULTI-CONTROL
again.
24
En
Selecting the search method
You can switch the search method between
fast forward/reverse and searching every 10
tracks.
1
Use MULTI-CONTROL to select
Search mode in the function menu.
Search mode appears in the display.
2
Press MULTI-CONTROL to select the
search method.
Press MULTI-CONTROL until the desired
search method appears in the display.
! FF/REV – Fast forward and reverse
! Rough search – Searching every 10
tracks
Searching every 10 tracks in
the current disc
If a disc contains over 10 tracks, you can
search every 10 tracks. When a disc contains
many tracks, you can roughly search for the
track you want to play.
1
Select the search method Rough search.
Refer to Selecting the search method on this
page.
2
Push and hold MULTI-CONTROL left or
right to search every 10 tracks on a disc.
# If a disc contains less than 10 tracks, pushing
and holding MULTI-CONTROL right recalls the
last track of the disc. Also, if the remaining num-
ber of tracks after searching every 10 tracks is
less than 10, pushing and holding
MULTI-CONTROL right recalls the last track of
the disc.