Blowing Feature - RIDGID HD09180 Mode D'emploi

OPERATION

Blowing Feature

Your Vac features a Blower Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blower Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Tug-A-Long Positive Locking
Hose with Dual-Flex Release Lever with
the Blower Port. Push the Hose End
straight into the Blower Port until the
Hose Release Lever fully engages the
Blower Port.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING:
!
Always wear
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using as
a blower.
WARNING:
!
To reduce the risk of injury to
bystanders, keep them clear of
blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates
dust which might be inhaled.
CAUTION:
!
To reduce the risk of hearing damage,
wear ear protectors when using the
Vac/Blower for extended time or in a
noisy area.
safety eyewear
Hose Release Lever
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Accessory
16
INSERT
HOSE
Blower Port
Swivel End
of Hose
Extension
Wand