On/Standby Mode; Operating Modes - De'Longhi AQVA Mode D'emploi

TURNING ON FOR THE FIRST TIME
After inserting the batteries, set the day of the week and
time.
Adjust the day of the week by using the "+" and "-"
pressing the "Mode" selection key.
just the hour by using the "+" and "-" keys and
Repeat the same procedure for the minutes.

4.3 ON/STANDBY MODE

In "Standby" mode, is displayed: "Stby".
All the operating modes are suspended ("Pilot
Wire" included), but the appliance is powered
and waiting for command reception.
To turn the appliance on or off, press the "Stand-
by" key.
The towel warmer turns on in the previously se-
lected operating mode and emits a beep.
When replacing the batteries, after setting day
and time the Control Panel starts in the mode
and temperature previously set.
The entry into "Standby" mode is signalled by
means of a double beep, the exit from "Standby"
mode by means of a long beep.

4.4 OPERATING MODES

The appliance provides 5 operating modes
which allow the user to heat the environment in
the most suitable way with respect to his needs.
Press the "Mode" selection key to select the
desired operating mode. An icon on the LCD
will show the selected operating mode.
Pilot Wire
Chrono
PILOT WIRE
The temperature depends on the "Pilot Wire" com-
mand.
All "Pilot Wire" commands are enabled.
-
Comfort
Anti-Freeze
21
COMFORT
The "Comfort" temperature corresponds to the tem-
perature desired by the user.
All "Pilot Wire" commands are disabled.
NIGHT/ECO
perature with a reduced energy consumption.
All "Pilot Wire" commands are disabled.
ANTIFREEZE
In "Anti-Freeze" mode, the temperature set point is
The appliance starts heating automatically when
the room temperature drops below 7 °C.
All "Pilot Wire" commands are disabled.
CHRONO
This operating mode allows to select either one out
of the two available Chrono presets (P1 and P2) or
the customizable Chrono program (P3). The latter
lets you set a daily and weekly program with two
All "Pilot Wire" commands are disabled.
4.4.1 PILOT WIRE
To activate the "Pilot Wire" mode:
Press the "Mode" selection key until the icon
\
appears on the LCD.
On the appliance the upper LED turns red.
Users can only set the "Comfort" temperature
on the Control Panel.
Select the desired temperature set point by
using the "+" and "-" keys.
porting this type of technology. In this case, correct trans-
ing the following diagram according to the mode set:
Mode Comfort (Comfort Anti-Freeze Standby
-3,5 °C)
Signal to be
transmitted
Voltage
between
0 volt 230 volt
Pilot Wire and
Negative
neutral wires
Comfort Comfort
-1 °C -2 °C
230 volt For 230 volt For
115 volt 115 volt
an interval an interval
Positive
of 3 s of 7 s
GB
-
-
-