Specifications Of The Appliance; General Information - De'Longhi AQVA Mode D'emploi

1. SPECIFICATIONS OF THE APPLIANCE

Voltage: 230 V ~ 50 Hz
GB
Insulation class: II
Protection class: IP34
Power [W]
Rated current [A]
Table 1
cated on the rating plate on the bottom right of the
towel warmer (Fig. 1).
A
B Model, type, category
C Voltage and Power
D Double insulation
E Country of origin
F CE marking

2. GENERAL INFORMATION

Storage and maintenance:
Avoid storing the appliance in places at risk of
freezing.
Protect from frost.
Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a soft support to avoid
damage.
The package contains:
– the appliance
– mounting kit
– instructions
– 2 alkaline batteries ("AAA" LR03 1,5V)
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing
the appliance.
Modifying the characteristics of the appliance and
200 300 400 500
0.9 1.3 1.8 2.2
-
G Serial Number
H Product Code
I Protection class
L Quality marks
M Disposal procedures
N Bidimensional Code (QR)
16
600 700 750 900
2.6 3 3.3 4
any way are expressly prohibited (Fig. 2).
Make sure the appliance is complete and undam-
aged. If damaged, do not use the appliance, but
sional.
The materials used for packaging can be recy-
cled. You are therefore recommended to dispose
of them in special differentiated waste collection
containers.
3. POSITIONING AND INSTALLING
This appliance is designed to heat domestic rooms or
similar and to dry towels.
WARNING:
This appliance is designed to dry towels washed in wa-
ter only. It must not be used for other purposes.
The appliance must be used permanently mounted on
a wall as described in the instructions.
Install the appliance with the control device at the bot-
tom right and the control buttons towards the front as
in Fig. 3.
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The towel warmer must not be connected
with a plug.
For radiators already fitted with power
plugs, see the warnings on page 27.
WARNING:
To avoid all risks for young children, install the ap-
1000 1250 1500 2000
4.5 5.5 6.5 9
-