De'Longhi AQVA Mode D'emploi page 20

Make sure the power cable cannot in any way come into contact with the surface of the appliance (Fig. 7).
GB
Fig. 8
Appliance cable
4. REGULATION AND OPERATION
This appliance is designed to heat
domestic rooms or similar and to dry
towels. Some parts of this product can
become very hot and cause burns. Par-
ticular attention has to be given where
children and vulnerable people are
present.
least 50 cm from the appliance. Do not vaporise
any type of substance on the surface of the appli-
ance.
Never touch the appliance with wet or damp
hands or feet.
Do not wet the electronic control unit with water
ance from the mains power supply and allow to
dry completely.
When the appliance is installed at high altitude,
the air will be hotter than the set temperature.
If you think room temperature could drop below
freezing point, activate the "Anti-freeze" mode.
To turn off the appliance completely, move
the main switch to the "O" position. This is
recommended whenever the appliance is not used
for long periods.
PHASE = BROWN
NEUTRAL = GREY
PILOT WIRE = BLACK
Two possible cases
Case 1: installation
without Pilot Wire
Case 2: installation
with Pilot Wire
-
-
18
PHASE
Household mains
NEUTRAL
Terminate and insulate
the wire
Connect to the Pilot Wire control unit or
transmission box
4.1 OPERATION
The appliance is controlled by the infrared Control Panel
which allows access to all functions.
tion), the towel warmer can be turned on and off using the
"Standby" button on the Command (Fig. 9, Section 4.6)
4.2 OPERATION WITH CONTROL PANEL
The appliance is controlled by an infrared Control Panel with
LCD display.
4.2.1 LED AND BUZZER
The control LEDS allow you to immediately recognize the
active mode (Fig. 9).
Fig. 9
LEDS
-
STANDBY button