Basic Procedure - Kenwood KDC-X720 Mode D'emploi

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (B) Trim plate
(C) Mounting sleeve (D) Wiring harness
(E) Extraction key (F) Screws (supplied for

Basic procedure

1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 41)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the [ terminal of the car battery.
5 Press to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds. ( 3)
40
ENGLISH
Installing the unit (in-dash mounting)
/ )
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the unit
with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
Hook on the top side
Orientate the trim plate
as illustrated before
fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate, then
pull it out.
3 Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
on the illustration.
Do the required wiring.
( 41)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.