Assembling manual
The UV lamp is also to be
cleaned before assembly.
It is to be inserted into the
head piece from above until
the two transparent catching
tabs of the connecting plug
lock into place in the head
piece.
The transparent lamp con-
nector must properly snap
into the groove on the head
piece.
Transparent connecting plug
Head piece
UV lamp
This figure shows the trans-
parent lamp connector
pushed too far.
Put the connection plug onto
the head piece until it clicks
in.
Transparent lamp
connection
UV lamp
Head piece
After the assembly of the UV
lamp the transparent lamp
connecting plug is to be fit-
ted on the head piece. Make
sure that it locks into place.
(See guide in the plug)
The connection plug is
properly installed. It does not
seperate when pulled away
from the head piece.
9