Assembly Of Reactor - ITT WEDECO Aquada 1 Manuel D'installation Et De Maintenance

2.1.1. Assembly of Reactor

• Before installation ensure you know which reactor type you are using.
(Information about the reactor type can be found on the type plate)
• Make sure that there is enough free space above the reactor (for dimensions see
section 2.1.), otherwise it will not be possible to install the UV lamp and to
maintain the system
• The reactor is to be fixed by means of the enclosed assembly clips either on the
wall or on a special holder
• In units with a UV sensor the reactor can only be assembled in a vertical position
• The assembled reactor is to be protected from frost exposure
UV lamp
Outlet
UV sensor (optional)
Control box
Inlet
7