Error Message Hb 10 Digital/Control - IKA HB 10 basic Mode D'emploi

Masquer les pouces

Table des Matières

Error message HB 10 digital/control

Any malfunctions during operation will be identified by an error message on the display (H), see fig. 6.

Proceed as follows in such cases:

☞ Switch off device using the main switch (B)

☞ Carry out corrective measures

☞ Restart device

Error message

E 2

E 3

E 9

E 21

E 23

E 24

E 25

E 26

E 27

E 28

E 29

E 30

If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:

- Contact the service department

- Send the device for repair, including a short description of the fault.

032009

Cause

- In remote operation (PC), no communication

between RV 10 and HB 10

- IR connection to RV 10 disconnected

- Temperature inside the device is too high

- Fault in storing the safety circuit set temperatures-

- Memory chip (EPROM) defective

- Safety relay does not open

- Adjustable safety circuit defective

- Set safety temperature exceeded

- The heater control circuit switch (TRIAC) is faulty

The heater or the supply line is disconnected

- Dry running

- Error in calibration

- Breakage of the controller sensor

- Short-circuit in the safety sensor

- Short-circuit in the controller sensor

Effect

Correction

Heating off

- Switch off the device

- Clean the IR interface or

remove objects from around the IR interface

- Switch on the device

Heating off

- Switch off the device

- Let the device cool down

- Switch on the device

Heating off

- Switch off the device

- Let the device cool down

- Switch on the device

Heating off