Cleaning Filters; Replacement Filters - shark VERTEX HZ2000 Série Guide De L'utilisateur

MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.

CLEANING FILTERS

Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
PRE-MOTOR FILTERS
With the dust cup detached, press the Filter
Access buttons on both sides of the back of
the dust cup, then pull out the filter housing.
Pull the foam filter out of the housing, then
lift out the felt filter by the pull tab.
The Pre-Motor Filters should be washed
once a month.

REPLACEMENT FILTERS

Replacement Pre-Motor Filter Kit
XFFKHZ2000
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
s h a r kc l e a n . c o m
POST-MOTOR FILTER
To access the post-motor filter, press the
release latch on the filter cover on the
handheld vacuum. Remove the cover and
lift out the filter.
The Post-Motor Filter should be washed
once every 9 months.
Replacement Post-Motor Filter
XPMFHZ2000
MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
Remove the handheld vacuum from the
wand and check all dust cup intake openings
for debris or blockages.
CHECK FLOOR NOZZLE
Detach the wand, then tilt the floor nozzle
Debris Intake back and check openings for
blockages.
CHECK WAND
Detach the wand and check it for blockages.
s h a r kc l e a n . c o m