shark VERTEX HZ2000 Série Guide De L'utilisateur page 3

(Click)
1. Insert Wand into Floor Nozzle.
(Snap)
3. Snap the Onboard Storage Clip onto the
wand, then place accessories in the holder.
Ensure all connections click securely into place.
s h a r kc l e a n . c o m
ASSEMBLY
1
(Click)
2. Insert Handheld Vacuum into wand.
3
4. For compact storage, hang the handheld
vacuum from the Storage Hook on the wand.
2
CONTROLS
The control panel is located on top of
the handheld vacuum.
4
BARE FLOOR SETTING
Bare Floor/Small Area Rugs
When powered on, the vacuum will
be in Bare Floor setting. In this setting,
the brushrolls spin slowly to clean bare
floors and small area rugs.
NOTE: Use the floor selector to toggle between Bare Floor and Carpet settings.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use the Carpet setting.
NOTE: Select Carpet for stuck-on dust and debris.
SETTINGS
POWER BUTTON
Power Button
Press the Power button to begin
vacuuming. Press again to turn
off power. Press the FLOOR TYPE
button to toggle between Bare
Floor and Carpet settings.
CARPET SETTING
Carpet
Press the FLOOR TYPE button to
switch to Carpet setting. The brushrolls
spin faster to pick up debris below the
surface of your carpets.
s h a r kc l e a n . c o m