Impact Drill; Declaration Of Conformity - Bosch PSB 500 RE Notice Originale

OBJ_BUCH-862-007.book Page 14 Monday, January 30, 2012 9:28 AM
14 | English

Impact Drill

Rated torque
Torque at max. output power
Right/left rotation
Dust Extraction
Spindle collar dia.
Max. drilling dia.
– Concrete
– Steel
– Wood
– with extraction device mounted
Chuck clamping range
Weight according to EPTA-Procedure 01/2003
– with extraction device
– without extraction device
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Engineering Director
Engineering PT/ESI
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
19.12.2011
Assembly
Before any work on the machine itself, pull the mains
plug.
Dust Extraction (PSB 500 RA) (see figures A
Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful to
one's health. Touching or breathing-in the dusts can cause
allergic reactions and/or lead to respiratory infections of
the user or bystanders.
Certain dusts, such as oak or beech dust, are considered
as carcinogenic, especially in connection with wood-treat-
ment additives (chromate, wood preservative). Materials
containing asbestos may only be worked by specialists.
2 609 005 111 | (30.1.12)
Nm
Nm
mm
mm
mm
mm
mm
mm
kg
kg
– As far as possible, use a dust extraction system suita-
ble for the material.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the
materials to be worked.
Prevent dust accumulation at the workplace. Dusts can
easily ignite.
Use the dust/chip extraction only when working con-
crete, brick and brickwork. Wood or plastic chips can
easily lead to clogging.
WARNING Fire hazard! Do not work metallic materials
with the extraction device mounted. Hot metal chips can
ignite parts of the extraction device.
F)
–
To achieve optimum extraction results, please observe the
following notes:
– Pay attention that the extraction device faces flush against
the workpiece or the wall. This also makes drilling at a right
angle easier.
– When using the extraction device, always work with the
maximum speed.
PSB 500 RE PSB 500 RA
1.1 1.1
7.5 7.5
–
43 43
10 10
8
25 25
13 13
2 – 13 2 – 13
– 1.8
1.6
/II /II
Bosch Power Tools
8
–