Wagan Tech 2509 Guide D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

600 Amp Battery Jumper
Wear complete eye and clothing protection. Do not touch eyes while working near or
with battery.
Keep battery terminals clean. Be careful to keep corrosion from coming in contact
with eyes.
Do not operate this unit in or around water. Water can damage the unit.
Do not let the cords of the jumpstarter or attached appliances get wet.
This product is not intended for use in the rain or temperatures above 130°F.
Never charge or jump-start a frozen battery.
To prevent short-circuits and arcing, never allow the metal ends/tips of clamps (positive &
negative terminals) to touch each other or connect to the same piece of metal.
Do not attempt to remove or replace the battery used in this device. When the battery has
reached the end of its lifetime, take the entire unit to a battery recycling facility.
Use only the provided chargers, cables, and clamps. Unauthorized parts may damage
the unit.
This product has no consumer serviceable parts.
For proper and safe operation of the 12 Volt DC power accessory outlets, do not place
anything into it except the plug of the accessory to be used.
CHARGING AND RECHARGING
† WARNING: Do not overcharge this unit� Overcharging may result in damage to the unit�
Prior to charging unit, read and understand all instructions for this unit�
This product may arrive partially charged from the manufacturer. It is recommended to fully
charge the unit immediately after purchase and before first use.
The red charging LED indicator will be illuminated while the unit is charging. After charging
period is completed, push the "Battery" button, and the three LED battery lights should light
up. The battery is now fully charged.
Do not charge the unit for more than 48 hours continuously.
Do not charge the unit on a boat, boat ramp, or dock since the electrical cords and outlets
used for charging could cause severe electrical shock if they get wet.
It is recommended that the unit is in an upright position while charging.
Charging with AC Charger
1. Insert AC charger plug into charging port of the unit.
2. Insert AC charger receptacle plug into AC receptacle.
3. Fully charge the unit.
First time charge: 38 hours continuously
Recharge or between use: 34-36 hours continuously
4. When charging is complete, unplug the AC charger receptacle plug then the AC charger
from the charging port on the unit.
5
by Wagan Tech
www.wagan.com
®

Publicité

Table des Matières
loading

Table des Matières