Air Compressor; Procedure - Wagan Tech JumpBoost V8 Air Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

JumpBoost™ V8 Air by Wagan Tech

AIR COMPRESSOR

The JumpBoost is equipped with an air compressor that can provide up to 250 PSI (pounds per
square inch) of pressure for a variety of uses such as vehicle tires and sports equipment.
CAUTION: Be careful not to over inflate, monitor the compressor gauge while inflating. Never
connect or disconnect the nozzle with the compressor operating. To avoid overheating, do
not operate the air compressor for more than 10 minutes at a time. After 10 minutes, allow the
compressor to cool for 15 minutes before using again.

Procedure

In the event that the vehicle tire is completely flat, raise the vehicle using a recommended jack
before inflating the tire.
1. Before any tire inflation, look for manufacturer's recommended inflation pressure.
2. Open the compartment door at the rear of the JumpBoost and extend the air hose.
3. Position the JumpBoost so that you can see the pressure gauge.
4. Make sure the chuck lever is positioned up (away from the chuck opening).
5. Determine if you will need an air hose adapter for your object.
• To inflate a vehicle tire:
a. Remove the valve cap from the valve stem of the tire.
b. Attach the chuck of the air hose to the tire's valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.
• To inflate a sports equipment, air mattress, rafts, or other plastic inflatables:
a. Insert the proper valve stem adapter into stem connector as far as possible.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable's air valve opening
as far as possible.
6. Set the Air Compressor Switch on to the "I" position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When recommended tire pressure has been reached, turn off the air compressor.
9. Disconnect the hose and replace valve cap.
10. Return the hose back to its compartment for storage.
11. Recharge the JumpBoost as soon as it is convenient.
12
®
www.wagan.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7552

Table des Matières