Weller WD 2 Mode D'emploi page 37

WD 2 / WD 2M
Unlock the soldering station:
1. Select the menu item LOCK in Menu 1.
"ON" appears in the display. The padlock symbol is displayed.
2. Enter the 3-digit lock code with the UP or DOWN button.
3. Press button ┌ 2 ┐.
The station is now unlocked. The display switches to the main
menu.
Note The soldering station can also be unlocked using a decoder list or
the reset connector.
7.2 Selecting Menu 2 special functions
Special functions
ID
FCC
1. Select the desired channel (see 6.1, on page 8)
2. Press and hold down the UP and DOWN buttons simultaneously.
"– 2 –" appears in the display after 4 s.
3. Release the buttons.
Selection of the special functions of Menu 2 is activated.
The settings can now be made.
- Select menu items with buttons ┌ 1 ┐ and ┌ 1·2 ┐.
- Exit the menu again with button ┌ 2 ┐ (EXIT).
Setting the station identification (ID code)
When the optional USB port is used, several WD 2 / WD 2M
soldering stations can be activated and remote-controlled to their full
operational extent. To this end, each station requires a station
identification (ID code) so that it can clearly identified.
1. Select the menu item REMOTE ID in Menu 2.
2. Enter an ID with the UP or DOWN button
(possible values 0 – 999).
3. Proceed to the next menu item with the button ┌ 1 ┐ (back) or
┌ 1·2 ┐ (forward).
Note Press button ┌ 2 ┐ to exit the menu item without changes (EXIT).
Navigation
┌ 1 ┐
┌ 1·2 ┐
┌ 2 ┐
EXIT
15-18