Weller WD 2 Mode D'emploi page 28

6-18
4.2 Specifications of the WD 2 / WD 2M
Dimensions
Weight
Mains supply voltage
Power consumption
Safety class
Fuse (12)
Temperature control
Temperature accuracy
Temperature stability
Soldering tip leakage
resistance (tip to ground)
Equipotential bonding
Equipotential bonding
4 variants are possible through connecting the 3.5 mm pawl
socket (8) differently:
− Hard earthed/grounded: without connector (delivery status)
− Equipotential bonding: with connector, bonding line at central
contact
− Floating: with connector
− Soft earthed/grounded: with connector and soldered resistor.
Earthing/grounding via the selected resistor
USB port
The WD 2M control unit is equipped with a mini USB port (13). For
the purpose of using the USB port, Weller software is available on a
CD with which you
− can carry out a software update ("Firmware Updater") on your
control unit and
− can remote-control the control unit and graphically display, store
and print temperature curves ("Monitor Software").
Note The WD 2 control unit can be retrofitted with a USB port.
L x W x H (mm): 134 x 108 x 147
L x W x H (inches): 5.27 x 4.27 x 5.77
approx. 3.7 kg
230 V, 50/60 Hz
120 V, 60 Hz
100 V, 50/60 Hz
160 W
I and III, housing antistatic
T 800 mA (230 V, 50 / 60 Hz)
T 1.6 A (120 V, 60 Hz)
T 1.6 A (100 V, 50 / 60 Hz)
50 °C – 450 °C (150 °F – 850 °F)
For WSP 150
50 °C – 550 °C (150 °F – 950 °F)
± 9 °C (± 17 °F)
± 5 °C (± 9 °F)
Complies with IPC-J-001D
Via 3.5 mm pawl socket on back of
device (8).
WD 2/ WD 2M