Repairs; Environmental Protection; Technical Specifications - Metabo SX E 425 TurboTec Mode D'emploi

17026838_0707 SXE Turbo NAFTA.book Seite 9 Dienstag, 10. Juli 2007 11:27 11
C Support plate with velcro-type fastening,
medium-hard (as replacement)
D Support plate with velcro-type fastening, soft
E Support plate with velcro-type fastening for
adhesive sanding discs with 6 or 8 holes
F Support plate for adhesive sanding discs
G Adhesive intermediate disc
H Adhesive polishing sponge
I Lambskin adhesive polishing disc
J Adhesive polishing felt
K Adhesive sanding fleece
L Adhesive sanding screen
M Dust collection box incl. fluted filter
(as a replacement)
N Fluted filter (as replacement)
O Brake ring (as replacement)
P Metabo universal vacuum cleaner
Q Connecting piece
For a complete range of accessories, see
www.metabo.com or the main catalogue.

11 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
If the mains connection cable of this machine is
damaged, it must be replaced by the manufacturer
or an authorized service centre to avoid hazard.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

12 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.

13 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
D = Diameter of support plate
P = Nominal power input
1
P = Power output
2
n = Idle speed (setting wheel)
0
n = Idle speed (TurboBoost switch)
0, TB
ENGLISH
n = Speed at rated load (TurboBoost
1, TB
switch)
s = Oscillating frequency at idle speed
0
(setting wheel)
s = Oscillating frequency at idle speed
0, TB
(TurboBoost switch)
s = Oscillating frequency at rated load
1, TB
(TurboBoost switch)
S = Oscillating circuit diameter
m = Weight without mains cable
During operation the noise level can exceed
85 dB(A).
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENG
9