Tips And Tricks; Accessories; Repairs; Environmental Protection - Metabo FSR 200 Intec Mode D'emploi

17026818_0810 FSR Intec NAFTA.book Seite 8 Montag, 9. August 2010 3:36 15
ENGLISH
ENG
- Refit fixing screws (on lower side of sanding
plate) and tighten.

9 Tips and Tricks

Do not press the device too firmly against the
surface being sanded. This does not improve, but
rather impairs, the sanding performance.
To optimise the extraction performance, empty the
dust collection box (5) in good time and clean the
fluted filter (7).
Use a suitable sanding disc to achieve the
best possible work results: Removal of old paint
layers = P 40
Pre-sanding of wood = P 60, P 80
Finishing of wood = P 100, P 120
Sanding of veneers, sealing primer, filler, paint = P
180, P 240

10 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Sanding plate (as replacement)
B Dust collection box with fluted filter for
multiple cleaning (as replacement)
C Fluted filter (as replacement)
D Perforated adhesive sanding discs for wood
and metal, 115 x 103 mm
E Perforated adhesive sanding discs for wood
and metal, for clamping 115 x 140 mm
F Perforated adhesive sanding discs for paint,
lacquer, spattle, 115 x 103 mm
G Perforated sanding discs for paint, lacquer,
spattle, for clamping, 115 x 140 mm
H Dust extraction connection
I Metabo universal vacuum cleaner
For complete range of accessories, see
www.metabo.com or the main catalogue.

11 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
8
Please enclose a description of the fault with the
power tool.

12 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.

13 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
D = Dimensions of sanding plate
P = Nominal power input
1
P2 = Power output
s = orbital frequency at no load
0
s = orbital frequency at nominal load
1
S = Oscillating circuit diameter
Intec = Dust collection box
m = Weight without mains cable
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).