Jumper Functions - Renkforce AC-239 Notice D'emploi

9. Jumper functions

The jumpers are on the PCB to the right of the connection terminal.
Jumper 1 (internal signalling device)
1 2
A
1 2
A
Jumper 2 (signal sounds)
1 2
B
1 2
B
ACTIVATED
DEACTIVATED
ACTIVATED
DEACTIVATED
In case of an alarm, an acoustic alarm is
triggered by the internal signalling device.
In case of an alarm, no acoustic alarm is
triggered by the internal signalling device.
This does not apply to the internal door bell
and the signal sounds.
a) When alarm zone 2 triggers, the system
issues short signal sounds by the in-
ternal signalling device while the entry
delay is active.
b) The alarm system emits a short signal
sound after the end of the exit delay and
arming of the alarm zones.
Insert jumper B to position 2 to deactivate
the signal sounds.
43