Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Plug the iron into the main outlet. The operation/temperature LED (5) will light
up. By default it will be selected at the lowest temperature range (•). The LED will
blink until the selected temperature level has been reached (fig.2-A). Take the
iron by the handle and pass the sole over the garment to be ironed.
TEMPERATURE SELECTION
The V50 has 4 temperature settings, which can be selected by pressing the
temperature selector (3).
Press the temperature selector (3) as many times as required until the desired
temperature level is reached (fig. 2). Position (•) (fig.2-A) Position (••) (fig.2-B)
Position (•••) (fig.2-C) Position (MAX) (fig.2-D)
The operation/temperature LED (5) will blink until the selected temperature
level has been reached. Once the temperature has been reached the LED will
stop blinking.
From the MAX temperature position, if pressed once again, the V50 will return to
temperature position (•).
STEAM SELECTION
Once the operation/temperature LED (5) stops blinking indicating that the selected
temperature has been reached:
•
For a steam jet, press one of the two steam buttons (4) on either side of the
handle (fig.3).
NOTE: When reducing the temperature, e.g. from position (MAX) (fig.2-D) to
position (•) (fig.2-A), the user can get a steam jet even if the position
(•) (fig 2-A) LED is still blinking and even if the selected temperature has not
been reached.
•
The V50 is ergonomically designed for both right-handed and left-handed
people. One merely has to press one of the two silicone buttons.
•
To stop the steam, press one of the two steam buttons one more time. The
steam will now stop until one of the two buttons is pressed again.
AUTOMATIC SHUT OFF
The Velocity V50 has an automatic shut-off system. It is shut-off automatically
eight minutes after the last time it was used. This means that once the shut-
off device is activated, it ceases to heat and begins to cool down. To wake it up
again, press the temperature button (3) for at least one second.
The auto-shut off mode can be manually selected by pressing the temperature
button for three seconds, and wake it up again by pushing the same button for
more than one second.
06
Publicité
Table des Matières
