Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FILLING WITH WATER
If during ironing the tank runs dry, after 30 seconds the operation/temperature
LEDs (5) of all the levels will start to flash. If the V50 is used without water for a
period of one minute, the micro-pump will stop.
Disconnect the iron, keep it in an upright postion and refill the tank using the cup
(6) that comes with it Fig 1. Plug the iron in again.
Once the V50 is plugged in, only the LED of the selected operation/temperature (5)
will light up.
NOTE: If the user fills the V50 without having it unplugged first, the LEDs will
continue blinking until the user presses the steam activation button (4) and the iron
steams for approximately 15 seconds.
ANTI - SCALE SYSTEM
This iron is equipped with a permanent anti-scale cartridge system installed
internally in the iron. It assists in keeping the internal tank clean. However it is
strongly recommended that you use the best water that is available to you as
outlined earlier in this manual.
CLEANING
A) Sole-plate
•
To remove starch, scorch, soil and other foreign residue, we recommend
using EZ-OFF iron cleaner. Please follow the instructions on the package.
B) Outer casing
•
To clean the outside of your iron, use a cloth moistened in soapy water.
•
Do not clean with abrasive chemical products or solvents as it may corrode
certain plastic parts and/or remove the graphics.
•
Store your iron in the vertical position, wind the cord around the heel and
secure it with the clip.
•
Although the power cord is fitted with a 360° rotational elbow, DO NOT
pull the cord too tightly when winding it around the iron on the first turn.
08
Publicité
Table des Matières
