Pre-Operation Checks - Honda Power Products HHH25D Manuel De L'utilisateur

For safe and efficient trimming, always make a pre-operation inspection
before operating:
Before performing a pre-operation inspection, place the hedge trimmer
on a level surface, stop the engine and make sure that the engine
switch is in the OFF position to be certain the engine will not start
accidentally.
1.Check the engine oil level
CAUTION:
Running the engine with low oil level will cause serious engine damage.
1.Install the cutter blade cover, place the hedge trimmer vertically on a
horizontal table, and hold the cutter blade.
HHH25D: Grip the rotation lever and rotate the rear handle 90°
clockwise or counterclockwise. Place the hedge trimmer on a level
surface and remove the oil filler cap.
HHH25D:
2.Check the oil level:
It should reach to the edge of the oil filler neck, and check the engine
oil for contamination and deterioration.
3.If the oil level is low, fill to the edge of the oil filler neck with the
recommended oil (see page 26).
If the oil is contaminated or deteriorated, replace it (see page 47).
4.Install the oil filler cap.

5. PRE-OPERATION CHECKS

HHH25S:
ROTATION
LEVER
25