Technical Specifications - Alto Professional RMX1008DFX Guide D'utilisation Rapide

TECHNICAL SPECIFICATIONS

MONO INPUT CHANNELS
• Microphone input: Electronically balanced, discrete input configuration
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD+N) 0.006% at +4dBu, 1kHz
• Gain: 50dB (MIC)
• SNR: (Signal to Noise Ratio) >90dB
• Line input: Electronically balanced
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD+N) 0.04% at +4dBu, 1kHz
• Gain: 30dB
STEREO INPUT CHANNELS
• Line input: Unbalanced
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD+N) 0.006% at +4dBu, 1kHz
IMPEDANCES
• Microphone input: 1.4k Ohm
• Channel Insert return: 2.5K Ohm
• All other inputs: 10k Ohm or greater
• Tape out: 1k Ohm
• All other outputs: 120 Ohm
EQUALIZATION
• Hi shelving: +/–15dB @12kHz
• Mid bell:
+/–15dB @2.5kHz
• Low shelving: +/–15dB @ 80Hz
DSP SECTION
• A/D and D/A converters: 24-bit
• DSP resolution: 24-bit
EFFECTS
• Hall, Room, Vocal & Plate reverbs Mono & Stereo DELAY (Max delay time 650ms) Chorus, Flanger & Reverb
Modulations, Reverb+delay, reverb+chorus, Reverb+flanger combinations
• Presets: 16
• Controls: 16-position PRESET Selector; 16-position Variation selector; Clip LED; Mute Switch with LED indicator
OUTPUT POWER
• Stereo mode: 400W(RMS) @ 4ohm, 480W(EIAJ) @ 4ohm, 254W(RMS) @ 8ohm
• Bridge mode: 945W @ 8ohm, 263W(EIAJ) @ 8ohm
POWER SUPPLY
• Main voltage: 100-120 VAC~60 Hz 210-240 VAC~50 Hz
• Fuse: 100 ~ 120V, T8 A
• Inrush current at initial switch-on: 3.82 A
• Inrush current after power supply interruption: 5.43 A
DIMENSIONS (W x L x H)
• 550mm x 220mm x 310mm (8.66" x 12.20" x 21.65")
NET WEIGHT
•
8.0kg (17.63lb)
250V; 220 ~ 240V- T6.3 A 250V
www.altoprofessional.com
MANUAL VERSION 1.1