Electrical Section - M-system MFCD 95 Série Mode D'emploi

10

ELECTRICAL SECTION

IMPORTANT: The cooker must be
installed in accordance with the
manufacturer's instructions.
Incorrect installation, for which the
manufacturer accepts no responsi-
bility, may cause injury to persons
or animals etc.
GENERAL
– Connection to the mains must be
carried out by qualified personnel in
accordance with current regulations.
– The appliance must be connected to
the mains checking that the voltage
corresponds to the value given in the
rating plate and that the electrical
cable sections can withstand the load
specified on the plate.
– The appliance can be connected
directly to the mains placing an
omnipolar switch with minimum opening
between the contacts of 3 mm between
the appliance and the mains.
– The power supply cable must not touch
the hot parts and must be positioned
so that it does not exceed 75°C at any
point.
– Once the appliance has been installed,
the switch must always be accessible.
Before effecting any intervention on
the electrical parts of the appliance,
the connection to the network must
be interrupted.
N.B. For connection to the mains,
do not use adapters, reducers or
branching devices as they can cause
overheating and burning.
If the installation requires alterations to the
domestic electrical system call an expert.
He should also check that the cable
section is suitable for the power absorbed
by the appliance.
IMPORTANT: this cooker must be
connected to a suitable double pole
control unit adjacent to the cooker.
WARNING!
This appliance must be earthed.
The connection of the appliance to
earth is mandatory.
T h e m a n u f a c t u r e r d e c l i n e s
a l l r e s p o n s a b i l i t y
inconvenience resulting from the
none observance of this condition.
f o r a n y
193