Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REPLACEMENT OF BURNER
INJECTORS
If the injectors are not supplied they
can be obtained from the "Service
Centre".
Select the injectors to be replaced
according to the "Table for the choice of
the injectors".
To replace the injectors proceed as follows:
- Remove pan supports and burners from
the cooktop.
- Using a wrench, substitute the nozzle
injectors "J" (figs. 9.10, 9.11) with those
most suitable for the kind of gas for
which it is to be used.
ADJUSTING OF THE MINIMUM OF
THE TOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The flame adjustment is done in the
following way:
•
Turn on the burner
•
Turn the tap to the MINIMUM position
•
Take off the knob
•
With a thin screwdriver turn the screw
"F" until adjustment is correct (fig.
9.12).
Normally for LPG, the regulation screw
is tightened up.
Gas maintenance
J
F
J
Fig. 9.10
Fig. 9.11
Fig. 9.12
191
Publicité
Table des Matières
