Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GAS TAPS
Periodic lubrication of the gas taps must be
carried out by specialist personnel only.
In the event of operating faults in the gas
taps, call the Service Department.
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface.
NOTE: The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
REPLACING THE OVEN LAMP
WARNING: Ensure the appliance is
switched off before replacing the lamp
to avoid the possibility of electric shock.
•
Let the oven cavity and the heating
elements to cool down.
•
Switch off the electrical supply.
•
Remove the protective cover.
•
Unscrew and replace the bulb with a
new one suitable for high temperatures
(300°C)
having
specifications: 230 or 220-240V, E14
and same power (check watt power
as stamped in the bulb itself) of the
replaced bulb.
•
Refit the protective cover.
Note: Oven bulb replacement is not
covered by your guarantee.
the
following
BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if cleaned
with products used for silverware.
After cleaning or wash, check that burner-
caps and burner-heads are dry before
placing them in the respective housings.
Check that the electrode "S" (figs. 7.1,
7.3) next to each burner is always clean to
ensure trouble-free sparking.
Check that the probe "T" (figs. 7.1, 7.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.
CORRECT REPLACEMENT OF THE
AUXILIARY, SEMI-RAPID AND RAPID
BURNERS
It is very important to check that the burner
flame distributor "F" and the cap "C" has
been correctly positioned (see figs. 7.1 -
7.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see fig. 7.5); the burner rib
must be enter in their logement as shown
by the arrow (see fig. 7.3).
Then position the cap "A" and the ring "B"
(figs. 7.4 - 7.5).
The burner correctly positioned must not
rotate (fig. 7.5).
173
Publicité
Table des Matières
