Technical Specifications - Evolite Diamond PLUS Mode D'emploi

DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
o
polarity.
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
o
fixture or the previous one.
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
o
damage or interference to DMX interface circuit.
 Some fixtures don't respond to the easy controller
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.
o
 No response to the sound
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.
o

Technical Specifications


Model
Voltage
Power consumption:
LED
Gross Weight
Package Dimensions
www.evolite-pro.com
Importé par / Imported by
EVOLITE – MSC
7 avenue du 1er Mai
91120 Palaiseau / FRANCE
infos@msc-distribution.com
Tel : +33 1 69 34 80 62
Diamond Plus User's Manual Ver. 1.00
DIAMOND PLUS
110V- 250V / 50-60Hz
750 W
19x40W OSRAM
18 kg
376x418x372 mm
DMX
53
Page