Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the noncompliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine. In addition to the safety
regulations in the operating instructions, you have to
meet the applicable regulations that apply for the op-
eration of the machine in your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed con-
cerning the operation of the machine and who are in-
formed about the associated dangers. The minimum
age requirement must be complied with.
2. Device description (Fig. 1/7)
1.
Handle
2.
Fuel tank cap
3.
Foot
4.
Operating bulb
5.
Oil check bulb
6.
On/off switch
7.
Earthing screw
8.
230 V~ socket
9.
Choke lever
10. Starter grip
11. Air filter lid
12. Air filter
13. Oil filler plug
14. Low oil trip
15. Spark plug cap
16. Spark plug
17. Fuel tap
18. Fuel filter
A. Oil filler bottle
B.
Handle
C. Screwdriver
D. Spark plug spanner
E. Socket wrench
F.
Tool bag
3. Intended use
The generator is suitable for devices which use a 230
AC voltage source.
Please check the suitability for use of house hold de-
vices on the manufacturer information.
The machine may only be utilised for its intended use.
Any other use is not intended. The user / operator, not
the manufacturer, is liable for resulting damages or
any type of injury resulting from any other use that is
not intended. Please ensure that this device was not
intended for commercial use. We do not accept any
warranty liability if the device is used for commercial,
manual, or industrial operations, or activities similar
to these.
4. Technical Data
Generator
Protection type
Continuous output P
(S1)
rated
Max. output P
(S2/5 s)
max
Nominal voltage U
rated
Rated current I
rated
Frequency F
rated
Type drive motor
Inverter
IP23M
1000 W
1200 W
230 V~
4,35 A
50 Hz
4 stroke air-cooled
GB / 15
Publicité
Chapitres
Table des Matières
