Operating Elements; Attaching And Securing The Battery - Torqeedo 401/801 Mode D'emploi

7. Operating elements

Socket for
power adapter
Contact panel

8. Attaching and securing the battery

1. Fit the battery pack. To do this, lift it with both hands and fit it into the shaft head from
above. Then swing the battery to the rear until it sits properly and engages.
2. You can additionally secure the
battery against accidentally coming
loose from the shaft with the bolt
supplied with the motor. You may
also slip a safety line through the
eye on the bottom of the battery.
3. The motor is ready to go under the following conditions
• The battery is charged
• The on/off pin is fitted.
• The steering cable is plugged in
• The tiller handle is in the stop position
• You have waited a short time after fitting the battery (< 5 seconds)
14
Operating instructions replacement battery
Charge status display
Battery charge key