Power Saving Mode; Performance - Toshiba Carrier MCY-MAP0367HS-UL Manuel Du Propriétaire

Masquer les pouces Voir aussi pour MCY-MAP0367HS-UL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Floor Console Exposed type
▼ When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼ When heating
Move the louver manually and point it downward to
send heated air to the floor.
Horizontal adjustment
Use the vertical grille behind the louver to even the
room temperature.
25-EN
◆ Changing the air discharge
Follow the procedure below to change the air
discharge:
1
Remove the two air discharge screws. The
screws are to be reused.
2
Insert your hand into the air discharge and
pull it up slightly, then remove the air
discharge from the claw hook at the rear
side.
3
Lift up the air discharge and remove it.
Vertical grille
4
Reverse the air discharge and reattach it to
the main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed screws so that it does not come off.
– 13 –
9

Power saving mode

Push
button during operation.
• The air conditioner enters power saving mode.
appears on the display.
Power saving mode remains in effect until it is
cancelled.
To cancel the power saving mode, push
button again.
disappears.
10

Performance

To save energy and perform comfortable cooling
and heating
Clean the air filter often
• A clogged air filter lowers the cooling/heating
performance.
Check
periodically!
Close windows and doors
• Do not let cooled/heated air escape from the room.
Close.
Do not cool/heat too much
WARNING
Do not expose your body to cool air directly for a
long time and do not cool yourself excessively.
Doing so may result in a deteriorated physical condition
and ill health.
NOTE
• The power saving mode consumes less energy,
however it may not heat/cool the room as much as the
normal mode.
• Even when operation start/stop, operation mode
change, or power reset is performed during the power
saving mode, the power saving mode is retained until
the next operation.
• Excessive Cooling/Heating is bad for your health.
In particular, take extra precautions with
handicapped/old people and children.
Do not cool
down too
much!
Cool/Heat the room evenly
• Adjust the air direction with the louver.
Exposing yourself to blowing air directly for a long
period of time is bad for your health.
26-EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mcy-map0487hs-ulMcy-map0607hs-ul

Table des Matières